Troubleshooting - Silhouette DAR055D1BSSPR Owner's Manual

Hide thumbs Also See for DAR055D1BSSPR:
Table of Contents

Advertisement

Available languages

Available languages

Occasionally, a problem is minor and a service call may not be necessary- use this troubleshooting guide for a possible
solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free Number
1-844-455-6097 for assistance.
PROBLEM
1) The refrigerator does
not operate.
2) The refrigerator is not
cold enough.
3) Turns on and off
frequently.
4) The light does not
work.
5) Vibrations.
6) The refrigerator seems
to make too much
noise.

TROUBLESHOOTING

POSSIBLE CAUSE
• Not plugged in
• The appliance is turned off
• The circuit breaker tripped or fuse has
been blown.
• Check the temperature control setting
• External environment may require a
higher setting.
• The door is opened too often
• The door is not closed completely
• The door gasket does not seal properly
• The room temperature is hotter
than normal.
• A large amount of beverage has
been added to the refrigerator.
• The door is opened too often
• The door is not closed completely
• The temperature control is not set
correctly
• The door gasket does not seal properly
• Not plugged in
• The circuit breaker tripped or a
blown fuse
• The light button is "OFF"
• Ensure that the refrigerator is level.
• The rattling noise may come from
the flow of the refrigerant, which is
normal. As each cycle ends, you
may hear gurgling sounds caused by
the flow of refrigerant in your
refrigerator.
• Contraction and expansion of the
inside walls may cause popping and
crackling noises.
• The refrigerator is not level
6
SOLUTIONS
• Plug in the unit.
• Press the ON button.
• Reset circuit breaker;
check fuses.
• Adjust setting as needed.
• Adjust setting as needed.
• Limit open door duration.
• Close door securely.
• Ensure the gasket is clean.
• This is normal.
• Limit amount of warm
beverage introduced at one time.
• Limit amout of door openings.
• Close door securely.
• Adjust setting as needed.
• Ensure the gasket is clean.
• Plug in the unit.
• Reset circuit breaker;
check fuses.
• Switch light button to "ON".
• Level the refrigerator. (page 2)
• This is normal.
• This is normal.
• Level the refrigerator.

Advertisement

Table of Contents
loading

Table of Contents