Operating Instructions - Silhouette DAR055D1BSSPR Owner's Manual

FUNCTIONS
Temperature Memory Function
• In the event of power loss the set temperature will be
saved by the unit. Once the power is back on the unit will
return the same set temperature.
Door Ajar Function
• If the door is not fully closed, there will be a warning
alarm after 5 minutes.
Temperature Alarm Function
• If inner temperature is higher than 73°F (23°C). The "HI"
is shown in display panel and the alarm will sound. It
informs you that the inner temperature is too high,
please check the reason why.
• If inner temperature is lower than 28°F (-2°C), the "LO"
is shown in display panel and the alarm will sound as well
the malfunction indicator light will illuminate.
CONTROL PANEL INSTRUCTIONS
Indicator light illuminates to signify the cooling mode
is currently in operation.
Control the interior light ON/OFF.
To turn on/off appliance (press and hold this button
for approximately 3 seconds).
Used to raise (warm) the temperature by 1°
increments.
Used to lower (cool) the temperature by 1°
increments.
(°C / °F) Adjacent indicator light denotes which scale
of temperature is displayed.
OPERATING INSTRUCTIONS
SHELVES
IMPORTANT!
Do not cover the gap on the glass shelves with aluminum
foil or any other material that will prevent adequate air cir-
culation within the cabinet.
When removing any of these shelves out of the rail com-
partment, you must first disassemble and remove the
plastic posts then remove the Lock screws that hold each
post in place.(Fig C)
To re-install, ensure the shelf is resting securely on the
support brackets and push shelf inward until it locks into
place.
Gap
SETTING THE TEMPERATURE
CONTROLS
When you plug in your refrigerator for the first time the
temperature will automatically be set to 41 °F (5°C) and
will be displayed in the Fahrenheit scale (°F)
• The temperature range can be set as low as 36 °F (2°C)
or as high as 50°F (10°C) to suit your specific storage
requirements. Each depression of the
will allow you to adjust the temperature in 1°degree incre-
ments within the aforementioned range.
• To switch the display between the Fahrenheit (°F) and
Celsius (°C) scale, depress the
simultaneously for approximately 3-5 seconds.
4
Lock Plastic
Screws Posts
Fig. C
or buttons
and buttons