Table of Contents
Advertisement
Available languages
Available languages
BEFORE USING YOUR
ALL REFRIGERATOR
• Remove the exterior and interior packing.
• Before connecting the refrigerator to the power
source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a
soft cloth.
• When disposing your appliance, please choose an
authorized disposal site.
INSTALLATION OF YOUR
ALL REFRIGERATOR
• Place your refrigerator on a floor that is strong enough
to support it when it is fully loaded. To level your
refrigerator, adjust the front leveling leg at the bottom
of the refrigerator.
• Locate the refrigerator away from direct sunlight
and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the exterior of the cabinet and
heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the
unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the refrigerator into an exclusive, properly installed
grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an
authorized service center.
NOTE
• In order for the refrigerator to remain efficient do not
over load it;
• Do not open the door unless necessary;
• Do not cover shelves with aluminum foil or any
other shelf material which may prevent air circulation;
• Should the refrigerator be stored without use for
long periods it is suggested, after a careful cleaning,
to leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible formations of
condensation, mold or odors.
INSTALLATION INSTRUCTIONS
INSTALLATION SPECIFICATIONS
FOR BUILT IN APPLICATION
TOOLS YOU WILL NEED
While performing installations described in
this section, gloves, safety glasses and
goggles should be worn.
Safety goggles
Electric drill with hole bit
Gloves
• It is recommended that you do not install the unit
directly beside a wall. This is to allow the door to have a
greater then 90° opening swing. A limited door swing
may lead to damaging the door gasket.
• The rough cabinet opening must be on a level floor area
1
and at least 23
/
" deep by 24
16
should also have a height of at least 34 9/16".
• The electrical outlet may be positioned from
within either side of the adjacent cabinetry, or the rear
of the shaded area (as shown in Fig B).
• If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2" diameter hole to admit the
power cord. If the cabinet wall is metal, the hole edge
must be covered with a bushing or grommet.
Fig.B
"
9
/
34
16
From underside
of countertop
to floor
3
Tape measure
Carpenter square
Flashlight
Level
1
/
" wide. The opening
16
1
1
/
" diameter hole
2
*If electrical outlet is
in adjacent cabinetry
23
1
min
24
1
/
"
16
1
3
/
16
Electrical Access
6"
/
"
16
*
"
Cabinet is
square
and plumb
Advertisement
Table of Contents
