Makita M432 Instruction Manual page 9

Finishing edges
To
trim edges or make dimensional adjust-
ments, run the blade lightly along the cut
edges.
For smoother cutting of plywoods or other
materials with easily splintered surfaces,
the wood may be coated or transparent
tape used over your cutting line.
Fig. 12
Using guide rule (Rip fence)
1. When cutting widths of under 150 mm
(6") repeatedly, use of the guide rule
will assure fast, clean cuts.
1
1
Fig. 13
2. To
attach the guide rule (rip fence), use
the hex wrench to loosen the screw on
the under side of the base in front, slip
in the guide rule and secure the screw.
I 1
Hex
wrench
Fig. 14
9