Fujitsu Siemens Computers x178 Operating Manual page 17

1 = Power connector
Ê
Be sure that the monitor and the computer are switched off.
The computer power plug must be pulled!
!
The data cable (2) is permanently attached to the monitor. It has a 15-pin D-SUB connector for the
monitor port of the computer.
Ê
Connect the 15-pin connector of the data cable to the (active) monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
If your computer has two monitor ports ("onboard" screen controller and separate graphics
i
card), the monitor port for the separate graphics card is usually active.
Ê
Plug the power cable supplied into the power connector of the monitor.
Ê
Plug the power cable into the monitor connector at the rear of the computer.
Ê
Plug the power connector of the computer into a properly grounded mains outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your graphics card/the associated driver software.
PD73M9L3-Z100-1-5E19
2
1
2 = Data cable
Colour monitor x178
English - 9