Makita 4341FCT Instruction Manual page 10

2
1
5
6
1. Graduations
2. Bevel slot
3. Base
4. Bolt
5. Gear housing
6. V-notch
1
2
1. Base
2. Bolt
3. Hex wrench
1. Starting hole
10
Tilt the base until the desired bevel angle is obtained. The V-
001941
3
notch of the gear housing indicates the bevel angle by gradu-
ations. Then tighten the bolt firmly to secure the base.
4
Front flush cuts
001942
Loosen the bolt on the back of the tool base with the hex
3
wrench, then move the tool base all the way back. Then
tighten the bolt to secure the tool base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
001943
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm (1/2") or more in diameter.
Insert the blade into this hole to start your cut.
1