Whirlpool 1CWTW4740YQ1 Use And Care Manual page 8

8, Select TEMPERATURE
CO°\
TEMPERATURE
all coJd rinses
Model 10WTW4840 shown
Once you select a cycle, select the desired wash temperature by
turning the Temperature knob to the appropriate setting based on
your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
iii'
Hot
Some cold water is added to save
energy. This will be cooler than your
hot water heater setting.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
; Warm
;;iSome cold water will be added, so Bright colors
; this will be cooler than what your Moderate to light soils
previous washer provided.
Cool
Warm water may be added to Colors that bleed
assist in soil removal and to help or fade
dissolve detergents. Light soils
Cold
This is the temperature from your Dark colors that
faucet. If your tap cold water is very bleed or fade
cold, warm water may be added Light soils
to assist in soil removal and help
dissolve detergent.
Select options, if desired
(on some models)
EXTRA RINSE
Model 1CWTW4840 shown
FABRIC SOFTENER
ADDED
Select the desired cycle options. If you are using fabric
softener, be sure to select one of the Fabric Softener
Added-Yes options.
Press START/Pause/Unlock
to begin wash cycle
START
Pause/Unlock
Hold O
3 sec to
cancel
Press the START/Pause/Unlock button to start the wash
cycle. When the cycle has finished, the DONE indicator will
light. Promptly remove garments after cycle has completed
to avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
IMPORTANT: After the washer basket fills to the selected
water level, the lid must be closed before the wash cycle
can start. If filling stops with the lid open, close the lid and
press START button.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause/Unlock again to restart the cycle.
If lid is left open for more than 10 minutes, the water will pump
out automatically.
8