Electrical Requirements; Install Leveling - Amana 4KWED4750 Installation Instructions Manual

ELECTRICAL REQUIREMENTS
ENectricaN Shock Hazard
ENectrically ground this appliance.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This dryer is supplied without an electric cord and plug.
It is your responsibility:
[] To contact a qualified electrical installer.
[] To be sure that the electrical connection is adequate and in
conformance with all local codes and ordinances.
[] To supply the required single phase, 240 volt, 60 Hz, AC
only electrical supply on a separate 30-amp circuit fused on
both sides of the line. A time-delay fuse or circuit breaker is
recommended. Connect to an individual branch circuit. Do
not have a fuse in the neutral or grounding circuit.
[] Do not use an extension cord.
[] If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
Electrical Connection
To properly install your dryer, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
if using a power supply cord:
[] If the supply cord is damaged, it must be replaced by the
manufacturer, a qualified service agent, or other qualified
person to avoid a hazard.
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
[] A UL listed 30-amp power supply cord, rated 240 volt
minimum. The cord should be type SRD or SRDT and be at
least 4 ft (1.22 m) long. The wires that connect to the dryer
must end in ring terminals or spade terminals with upturned
ends.
[] A UL listed strain relief.
Connecting by direct wire:
Power supply cable must match power supply and be:
[] Flexible armored cable or nonmetallic sheathed copper cable
(with ground wire), covered with flexible metallic conduit. All
current-carrying wires must be insulated.
[] 10-gauge solid copper wire (do not use aluminum).
[] At least 5 ft (1.52 m) long.
[] Disconnection must be incorporated in the fixed wiring in
accordance to the wiring rules for your region.
Recommended Grounding Method
[] It is your responsibility to contact a qualified electrical installer
to ensure that the electrical installation is adequate and in
conformance with all local codes and ordinances.
GROUNDING INSTRUCTIONS
m=For a grounded, cord-connected dryer:
This dryer must be grounded. In the event of malfunction or
breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING:
improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly grounded. Do not modify the plug provided with the
dryer: if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
SAVE THESE INSTRUCTIONS
INSTALL LEVELING LEGS
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1. Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
6