GE CYE22TSHBSS Owner's Manual And Installation Instructions page 25

Installation Instructions
INSTALLING THE REFRIGERATOR (cont.)
REMOVETHEREFRIGERATOR DOORS(cent)
Note: for proper installation later, please follow the next step
carefully.
F] Fresh Food doors to be .REMOVED and INSTALLED
opened at 90 ° with case front,
Lift up & off
center hinge
)en Door to
90°
REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite
door, There are no wires or water lines on the opposite
side
TIREMOVE CENTER HINGE (if necessary)
Remove the 3/8" screws securing the center hinge to the
cabinet, Use T20 driver to remove outboard screw
Remove
center screw
¢
Loosen Outer screws
E]REINSTALLING THEREFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator, follow
details below for critical alignments,
r_ Reinstall center hinge first and torque the screws to 65
in-lbs. With the LH door at 90 ° to the front of
the case, lower the refrigerator door onto the center hinge,
Ensure that the door and hinge align correctly,
mm
r_ Rotate doors closed and make sure moveable center sealing
portion of the door aligns with the striker,/fthe door willnot
selftclose after reinstalling, remove door, turn door upside dowf
check alignment mark and arrow; (there is an alignment rm?rk
on the door closure mechanism/t corresponds to an alignment
mark on the bottom end cap, Rotate door closure mechanism
to align mark and arrow, reinstall door),
@
Underside of Fresh Food Door
align marks
If door cannot be installed at 90 ° follow steps below:
1. If space or model limits opening door to less than 180 °, then:
a) Remove door, carefully turn door upside down.
b) Check alignment of door closure mechanism shaft on
underside of door. The flats on the shaft should
correspond to alignment tab on plastic ring or mark
on bottom end cap.
c) If shaft is not aligned to tab/mark, using 5/32" Allen
wrench, rotate door closure mechanism shaft
counterclockwise for right door and clockwise for left
door. Then align flat with tab/mark.
d) Install the door at 90 _'.
Securely tape the door shut with masking tape or have a
second person support the door. Reinstall the top hinge
and torque the screws to 65 in-lbs.
r_Be sure to reinstall the ground wire and strain relief to the top
hinge,
r_ Reinstall the hinge cover, Note: Ensure wires are not pinched or
under screw bosses before tightening screws,
25