LG WM3250HRA Owner's Manual page 14

14
INSTALLATION INSTRUCTIONS
Connecting the water lines
Check the rubber seals on both sides of the hose
- Insert a rubber seal into the threaded fittings on each
hose to prevent leaking
Rubber seal
_--_ _ Rubb ..... I
4 Connect the hoses to the water inlets tightly by hand and
then tighten another 2/3 turn with pliers.
- Connect the blue hose to the cold water inlet and the red
hose to the hot water inlet
__
Water hose
(To water inlet on the
washing machine)
hose
I (To faucet)
Connect the water supply hoses to the HOT and COLD
water faucets tightly by hand and then tighten another 2/3
turn with pliers.
- Connect the blue hose to a cold water faucet and the red
hose to a hot water faucet
_A WARNING ...............................................................................................................................
" Do not Damage to the coupling result.
overtighten,
can
3 After connecting inlet hose to water faucets, turn on the
water faucets to flush out foreign substances (dirt, sand or
sawdust) in the water lines Let water drain into a bucket,
and check the water temperature
, A WARNING ....................................................
Do not overtighten the hoses. Overtightening can
damage the valves resulting in leaking and property
, damage
5 Check for leaks by turning on the faucets
- If water leaks, check steps 1 to 4 again
r@ NOTE ...............................................................
For your safety, and for extended product life, use
only authorized components The manufacturer is not
responsible for product malfunction or accidents caused
by the use of separately purchased unauthorized parts
Use new hoses when you install the washing machine.
De not reuse old hoses Use only the inlet hoses
provided with the washer LG does not recommend the
use of aftermarket hoses.
Periodically check the hoses for cracks, leaks and wear,
and replace the hoses every 5 years.
De not stretch the water hoses intentionally, and make
sure that they are not crushed by other objects.
Water supply pressure must be between 14.5 PSI and
116 PSI (100~800 kPa) If the water supply pressure is
more than 116 PSI, a pressure reducing valve must be
installed
• To provide optimum washing performance the hot water
temperature should be set at 120-135°F (48-57°C) and
the cold at 60°F (15°C).