GE CDT765SSF1SS Installation Instructions Manual page 7

Dishwasher Installation
STEP 6: REMOVE FLOOR PROTECT
Squeeze connector at top
, Disconnect leak sensor wire
to release snap feature
(on some models).
Remove 2 screws from front of the
Floor Protect with a 1A"driver.
Rotate Floor Protect outward and lift
out of the mounting tabs.
Set aside for use in Step 22.
z_ Leak Sensor
J
f" Floor Protect
Figure L
STEP 7: INSTALL 90 ° ELBOW
. Thread 90 ° elbow
onto the water valve.
Do not overtighten
Water Valve
elbow. Water valve
Bracket
\
bracket could
bend or water valve
fitting could break.
Position the end of
the elbow to face the
rear of the dishwasher.
Front of dishwasher
90° Elbow
Figure M
STEP 8: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure N
NOTE:The high drain loop on the side of the tub is designed for
better wash performance. Do not remove from the side of the tub.
STEP 9: POSITION WATER LINE
AND HOUSE WIRING
Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Line Wiring
Figure O
STEP 10: INSTALL DRAIN HOSE,
THROUGH CABINET
, Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate hole.
Maximum Drain Hose
Length 15'
Insulation ..
Blanket .._.
Hose
/
House
Wiring
\
PowerCord
(if Used)
Figure P
Tip: Prevent unnecessary service call charges for fill, drain
or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.