Advertisement
Available languages
Available languages
Dishwasher
Installation
STEP 1:PREPARATION
Locate the items in the installation package:
, Screws
Junction box cover
Drain hose and clamp
Mounting brackets
Trim pieces (on some models)
Drain hose hanger
Owner's Manual
Product samples and/or coupons
STEP 2: CHECK DOOR BALANCE
/
NOTE:If installing a Cus-
tom Door Panel (available
on some models), please
follow the instructions
found in the Custom
Door Panel kit.
With dishwasher on
the wood base, check
the door balance by
opening and closing
the door.
Door
/
closes
/
within
/
20 °
/
/
/ Door stays in
position
from
_
_-
20 ° to 70 °
_
_
"1_
_
_ _oor_ falls fully
j
open beyond
70°_
"
Side View
I
. Door is properly
F_g.roG
balanced if, when
opened, it self closes within 20° from vertical, stays in position
from 20 ° to 70° and falls fully open beyond 70°.
If necessary increase or decrease tension as shown. Some
models will have i spring on each side and other models will
have 2 springs on one side and i spring on the other side.
Latch door and adjust springs to correct balance.
Side View
--
Custom
door
panel
Increase
_nt
View
Tension
Spri
(_
Make sure pulley cables
hooked
\_
/
are within pulley shoulders
to screw
\_
/
Decrease
Tension
inside leg
Figure H
Tip: Make sure door opens and closes smoothly.
Check door opening and closing. If door does not open easily or
falls too quickly, check spring cable routing. The cable is held in
place by "shoulders" on the pulley. Check to be sure cable has
not slipped over the pulley shoulders and is routed as shown.
STEP 3: REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
- Do not kickoff wood base!
Damage will occur.
Move the dishwasher close to the installation location and lay
it on its back.
Remove the 4 leveling legs on the underside of the wood base
with a 15/16" socket wrench.
. Discard base.
Figure I
. Screw leveling legs back into the dishwasher frame,
approximately 1/2" from frame as shown.
NOTE:Some models have rear adjustable leveling wheels, and
will not require the 2 rear leveling legs.
STEP 4: REMOVE TOEKICK
Remove the 2 toekick screws and toekick. Set aside for use in
Step 24.
Remove 2
Figure J
Toekick Screws
STEP 5: POSITION SOUND BARRIER
(on some models)
Skip this step if the sound
barrier is not assembled
to the dishwasher.
Lift the sound barrier and
tape to the door front with
masking tape. This will
hold the sound barrier up
and out of the way during
installation.
Tape\_
Sound Barrier
Figure K
Bottom Front View
Advertisement
