• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by Rane Corporation could void the user's authority to operate the equipment. This Class B digital apparatus complies with Canadian ICES-003.
• Consulter un revendeur ou un technicien radio / TV expérimenté. ATTENTION: Les changements ou modifications non expressément approuvés par Rane Corporation peuvent annuler l'autorité de l'utilisateur à manipuler cet équipement et rendre ainsi nulles toutes les conditions de garantie.
2 controls go dormant and the LEDs extinguish. If While sending a signal to the DC22S, adjust the output the LINK switch is off, then both channels are independently level of the previous device so the +4 dBu LED lights occasion- controllable.
Page 5
GATE COMPRESSOR OUTPUT DC22S LINK DYNAMIC CONTROLLER GAIN MASTER SLAVE LEVEL THRESHOLD THRESHOLD RATIO REDUCTION BYPASS LEVEL POWER When the POWER LED is lit, the DC22S is connected to a 100-240 VAC source and ready to rock. Manual-2...
• SEE THE RANENOTE: SOUND 50/60 Hz 7 WATTS SYSTEM INTERCONNECTION BALANCED BAL/UNBAL BALANCED BAL/UNBAL BALANCED BAL/UNBAL BALANCED BAL/UNBAL DC22S STEREO COMPRESSOR MONO SUBWOOFER TTM 56S COMMERCIAL AUDIO EQUIPMENT 24TJ MADE IN U.S.A. RANE CORP. U.S. PATENT 6,813,361 PHONO MASTER GROUNDS...
Page 7
3. COMPRESSOR RATIO ....fully counterclockwise INPUT (dBu) 4. BYPASS switches .....ACTIVE (out) Figure 2. With the Ratio set to ∞, the DC22S acts as a Limiter. This 5. OUTPUT LEVEL ......0 dB This renders the DC22S with no compression, allowing sig- graph shows Limiter gain reduction above various Compressor nal through at unity gain.
Page 8
Channel 1 and right signal in Channel 2, it is recom- mended to turn the LINK switch on to prevent large balance The DC22S is excellent as a line level amp for driving long lines and image shifts. While LINKed, both Channels attenuate by (from the mixer to the stage for instance).
Page 9
NOTES Any change in amplifier sensitivity setting will effect the power limit to the driver. If the DC22S is placed just before the amplifier, no other system levels will effect the power limit setting. EXAMPLE 1. Driver power rating: w = 100 watts.
The user of this equipment shall accept full responsibility for compliance with the LV directive and EMC directive in the event that the equipment is modified without written consent of the manufacturer.This declaration of conformity is issued under the sole responsibility of Rane Corporation. Type of Equipment: Professional Audio Signal Processing...