SAFETY INSTRUCTIONS WARNING: Read the safety warnings and all instructions before use. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. Work area 1. Always keep work area clean and bright. Cluttered and dark areas easily induce accidents.
2. Use personal protective equipment. Always wear eye protection. Always use protective equipment such as duct mask, non-skid safety shoes, hard hat, or heating protection for appropriate conditions will reduce personal injuries. 3. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack.
6. Use the power tool, accessories and tool bits, etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation.
5. Do not use an extension cord unless it is absolutely necessary. To use an improper extension cord may cause the risk of fire, electric shock or electrocution. 6. Do not use the charger if it has been subjected to a heavy knock, dropped;...
CHARGING INSTRUCTIONS Smart cellular phone Charger or iPhone/iPad/iPod charger Micro USB *Please use smart phone charger, power bank, iPhone/iPad/iPod charger for charging the power tool. *Please use our authorized USB cord for iPhone/iPad/iPod user. *The charging indicator will be Red when in charging, the light will be change to Green when fully charged.
Page 7
EXPLANATION OF GENERAL VIEW Drive (Collet) 1/4”(6.35mm) LED light Switch (Forward/Reverse) Charging indicator SPECIFICATION Rated no load speed 350 rpm Output torque 3 Nm (31 kgf-cm/26.9 lbf-in) Drive (Collet) 6.35mm (1/4") Hex insert chuck Switch for forward or reverse rotation. Special function Includes LED light.
OPERATING INSTRUCTIONS 1. Attaching and removing accessories Inst alling Installing the accessory (bit): Insert the accessory shank to the chuck. Remove the accessory (bit): Remove the accessory from the chuck. Remove **Do not shake the tool or press the trigger when installing or remove the accessory.
MAINTENANCE CAUTION: Always be sure that the tool is triggered off before inspection or maintenance. Inspecting screws of the tool To make sure all of threads are fasten with correct way and tight after disassembly or maintained the tool. Maintenance of tool Please clean up the tool regularly with dry wiper.