Kenmore 795.51379012 Use & Care Manual page 28

Not disensing ice. Aii the doors are not closed completely. Ice wiii not dispense if any of the refrigerator doors are left
open. Check if something is holding the door open.
The dispenser display is locked. Press and hold the Door Alarm button for 3 seconds to unlock
the control panel and dispenser.
Ice is not selected on the dispenser The dispenser can be set for ice or water. Make certain
that the control panel is set for the proper operation. Press
the dispenser Ice & Water button on the control panel to
cycle through the ice and water options.
The ice dispenser is not used often Check the ice bin for ice cubes clumping/sticking together.
If they are, break up the ice cubes to allow for proper
operation.
Ice bin is not installed correctly. Be sure to install the ice bin firmly into position
New installation Wait 24 hours after icemaker installation for ice production
to begin. Wait 72 hours for full ice production. See the
CONTROL PANEL FEATURES section.
Ice cubes are stuck in the delivery Use a plastic utensil to clear the delivery chute.
chute.
The ice dispenser is stalling while Change the ice button from crushed to cubed. If cubed ice
dispensing crushed ice. dispenses correctly, depress the button foP'crushed" ice and
begin dispensing again
Icemaker power switch in the OFF (O) Move the switch to the ON (I) position.
position.
Water supply turned off or not See the CONNECTING THE WATER LINE section.
connected.
Not dispensing The dispener display is locked. Press and hold the Door Alarm button for 3 seconds to unlock
water, the control panel and dispenser.
New installation. Flush and fill the water system.
Refrigerator or freezer doors are not Water will not dispense if any of the refrigerator doors are
closed properly, left open.
Water supply turned off or not See the CONNECTING THE WATER LINE section.
connected.
The water pressure is less than 40 psi. The water pressure to the home affects the flow from the
dispenser.
Home filter or reverse osmosis system is This can decrease water pressure. It is recommended not
used. to connect the supply line to a reverse osmosis system for
optimal operation.
The dispenser is not set for water The dispenser can be set for ice or water. Make certain that
dispensing, the control panel is set for the proper operation. Press the
dispenser button on the control panel to cycle through the ice
and water options.
Water filter needs to be changed. The filter should be changed every 6 months or more often
depending on usage. The filter can become blocked over
time with foreign particles and reduce the water pressure.
29