Maintenance; Sanding Operation - Makita 9227C Instruction Manual
180 mm (7”) electronic sander polisher
Hide thumbs
Also See for 9227C:
- Instruction manual (25 pages) ,
- Operating instructions manual (8 pages) ,
- Parts breakdown (3 pages)
Table of Contents
Advertisement
OPERATION
MAINTENANCE
10
Polishing operation
003478
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
Hold the tool firmly. Turn the tool on and then apply the wool
bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to wool bonnet.
Sanding operation
003473
CAUTION:
•
Always wear safety goggles or a face shield during
operation.
•
Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
•
Never run the tool without the abrasive disc. You may
seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the abra-
sive disc to the workpiece.
In general, keep the abrasive disc at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to abrasive disc.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Hide quick links:
Advertisement
Table of Contents
