Craftsman 358.381700 Operator's Manual page 15

overcut leaving a t to 2 inch (2.5 to 5
cm) collar from the truck of the tree.
Seoondoot J
Third CUt i_,_y/ irJ
i i ::
: Pruningtechnique
CUSTOMER RESPONSIBILITIES
A_ILWARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
Fill in dates as you complete Before After' Every I Every '
regular service Use , Us e 5 hrs. 125 hrs. "Yea!y
' Check for damaged/worn parts _r i i
E
' Check for loose fasteners/parts _' ! i
Check chain tension _"
Check chain sharpness _.- i i
i
i I
Check guide bar
Service
Dates
........................................................................................ I...............................
Check fuel mixture level i
Ch.eck..guid# .bar..and cha!n 0.il i ! ! '
i 1 i I :' : i t
Inspect and clean unit & decals i _ _ 1
............ - ................... .................................. _ i t i ! .....................
,Clea, n ,c,0o,!!ngsystem .......... i ! _' I .... i i
Check chain brake i ' _ _' !
Clean guide bar groove i _"
Clean ............................... air filter -* '*_- ........ _................................................................. _" i_ . ............. :......................... ii . ................
Clean/inspect muffler and spark !
arresting screen i v"
! i
i apiece spark plug and fuel filter v" i
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive fufivalue from the warranty, the
operator must maintain unit as
instructed in this manual, Various ad-
justments will need to be made period-
ical]y to properly maintain your unit.
- Once a year, replace the spark plug,
air filter, and check guide bar and
chain for wear. A new spark plug and
air filter assures proper air, fuel mixture
and helps your engine run better and
last longer,
CHECK FOR DAMAGED 0R _i, _:
WORN PARTS
Contact your Sears Service Center for
replacement of damaged or worn parts.
NOTE: It is normal for a small amount of
oil to appear under the saw after engine
stops, Do not confuse this with a leaking
oii tank,
• ON/STOPSwitch - Ensure ON/STOP
sw_tchfunctions properly by moving
the switch to the STOP position, Make
15