Table of Contents
Advertisement
To reduce the risk of e_ectricam shock,
disconnect
this appliance
from the power
suppmy before
attempting
any user maintenance.
Turning
the controls
to the OFF position
does not disconnect
this appliance
from the power
supply.
Refer to the washer
and dryer
installation
instructions
packed
with each
appliance
prior to stacking
appliances.
Reading
aH of the information
contained
in these
instructions
will simplify
the installation
and ensure
a correct
and safe operation.
A fire
hazard and/or
persona_
injury
could
result
from improper
installation.
TOOL & EQUIPMENT
REQUIREMENTS:
1. Phillips screwdriver.
2. Channel-lock
pliers.
Mounting
the Dryer to the Washer:
,
,
,
,
Remove the washer top panel by first
removing the four (4) screws in the
two (2) brackets
located on the top
rear of the washer.
Slide the top forward,
lift the front of
the top up, and remove the top panel.
Remove the two (2) brackets from the
rear of the top panel.
Using the four (4) screws that were
removed in step 1, install the
brackets in the rear support as
shown.
Remove the four (4) screws and the
two (2)long
front brackets located on
the top front of the washer.
Install the two (2) new front mounting
brackets, provided
in the kit, with the
four (4) screws that were removed in
step 3. Note that the tab of the front
mounting bracket is facing forward
as
shown in the illustration.
I
I
' @
I
I
I
I
I
I
' :G
I
I
I
I
I
I
V
Numbers
correspond
to steps.
11
Advertisement
Table of Contents
