Advertisement
Adjusting the driving depth
Depress the stopper plate as far as it will go.
While keeping it in this position, turn the
adjusting knob until the bit tip projects
approx. 5 mm
(3/16")
from the stopper plate.
Drive a trial screw.
If
the screw head projects
above the surface of the workpiece, turn the
adjusting knob in the Wdirection; if the
screw head is countersunk, turn the adjust-
ing knob in the
B
direction.
Approx. 5
mm
(3/16")
c
Casing
Stopper plate
Adjusting knob
Installing the screw strip
Insert the screw strip through the screw guide. Then insert it through the feeder box until
the first screw reaches the position next to the driving position.
Screw guide
p e d e r box
Driving position
Removing the screw strip
To remove the screw strip, just pull it out in
the direction of the arrow.
9
Advertisement
