Advertisement
Installing or removing the bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Loosen the bolt which secures the casing. Pull out the casing
in
the direction of the arrow.
Press the dust cover toward the plane bearing and pull out the bit. If the dust cover cannot
be moved as far as the plane bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it slightly. After installing, always
make sure that the bit is securely held in place by trying t o pull it out.
Thickness of
drywall
Application
7asing
Foundation for
Fastenings
drywall
Battery 1200
Battery 1201
Hex wrench
Drywall screw
4.0
m m
x 4 0 mm
(5/32" x 1-9/16")
Plane bearing
Dust cover
I
18
mm
(23/32")
Wood or plywood
Approx. 230 screws
Approx. 330 screws
Screwdriving performance
The following reference table indicates the approximate screwdriving capacities from a single
charge. It may differ under some condition.
1
Drywall screw
Steel stud
15/32" x 1")
thick
4.0 mm x 25
mm
12
mm
(1 5/32")
0.5
mm
(1/64")
Approx. 430 screws
Approx. 610 screws
CAUTIO N :
If the tool is operated continuously until the battery cartridge has discharged, allow the
tool to rest for 15 minutes before proceeding with a fresh battery.
MAINTENANCE
CAUTl ON:
Always be sure that the tool is switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, maintenance or adjustment should
be performed by Makita Authorized or Factory Service Centers, always using Makita replace-
ment parts.
11
Advertisement
