Advertisement
Always switch off the tool before insertion
or removal
of
the battery cartridge.
To remove the battery cartridge, pull out the
set plate on the tool and grasp both sides
of the cartridge while withdrawing it from
the tool.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into place.
Snap the set plate back into place. Be sure
to close the set plate fully before using the
tool to prevent the battery cartridge from
accidentally falling out of the tool.
Charging
Your new battery cartridge is not charged.
You will need t o charge it before use. Use
the fast charger Model DC1201 to charge
the battery cartridge.
Plug the fast charger into the proper A/C
voltage source The charging light will flash
in green color.
Insert the battery cartridge so that the plus
and minus terminals on the battery
cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so
that it rests on the charger port floor.
Battery cartridge
7
1 2 0 0
:artridge
charger
Approx. 45 min.
When the battery cartridge is inserted, the charging light color will change from green
to red and charging will begin. The charging light will remain lit steadily during chrging.
When charging is completed, the charging light color will change from red t o green and
a tone will sound steadily for about 5 seconds.
After charging,
unplug
the charger from the power source. Refer to the table below
for
the charging time.
Fast charger
DC1201
Battery cartridge
1 2 0 1 or 1201A
Approx. 60 min.
7
Advertisement
