Cutting depth adjustment
1. Loosen the wing bolt.
2. Obtain the desired cutting depth.
3.
Tighten the wing bolt.
I
Base
Securing safety guard
The safety guard can be adjusted about 80
degrees, after you loosen the wing nut.
Adjust to the desired angle, then secure the
wing nut.
I
Safety guard
Wheel changes
I
To replace the abrasive cut-off wheel,
depress the shaft lock to hold the shaft
stationary, then loosen the hex bolt with
the socket wrench provided.
Be sure to fully tighten the hex bolt when
mounting the new wheel, or operation will
be dangerous.
NOTE : Hex bolt has a left-hand thread.
6