About The Radiant Surface Elements; Element On And Hot Surface Indicator Lights; Element Indicator Light - Kenmore 790.42532310 Use & Care Gude

Before Setting Surface Controls
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As the
temperature rises, the element will glow red. To maintain the
selected setting the element will cycle on and off. The heating
element retains enough heat to provide a uniform and consistent
heat during the off cycle.
For efficient cooking, turn off the surface element just before
cooking is complete. This will allow residual heat to complete
the cooking process.
Radiant surface elements may appear to have
cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched
before it has cooled sufficiently.
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on top of
the range when it is in use. These items could melt or ignite.
Potholders, towels or wooden spoons could catch fire if placed
too close to the surface elements.
Do not allow aluminum foil, empty glass/
porcelain cookware or any material that can melt to make
contact with the ceramic cooktop. If these items melt on the
cooktop they may damage the ceramic cooktop.
Element On and Hot Surface Indicator Lights
Your appliance is equipped with two different types of surface
control indicator lights that will glow on the control panel-- the
ELEMENT ON indicator light and the Hot Surface indicator
lights.
The ELEMENT ON indicator lights are marked on the control
panel and will glow when a surface cooking element is turned
on. A quick glance at these indicator lights after cooking is an
easy check to be sure all surface controls are turned off.
Figure 4:
ELEMENT ON
Element indicator light
The Surface indicator light is located on the cooktop. It will glow
when any cooking area heats up and will remain on until the
cooktop has cooled to a moderate level.
HOT SURFACE
Figure 5: Element indicator light
Important notes:
Never place or straddle a cooking utensil over two different
surface cooking elements at the same time unless the utensil
is designed for that purpose. This can cause uneven heating
results. This can also cause the ceramic cooktop to fracture.
Radiant elements have a limiter that allows the radiant
heating element to cycle on and off, even at the HI setting.
This helps to prevent damage to the ceramic smoothtop.
Cycling at the HI setting is normal and will occur more often
if the cookware is too small for the radiant element of if the
cookware bottom is not flat.
Be sure to read the detailed instructions for ceramic glass
cooktop maintenance and cleaning in the "Care &
Cleaning" and "Before You Call" checklist sections of this
Use & Care Guide.
10