Operation - Makita 6705D Instruction Manual

12mm(15/32")
9mm(3/8")
1
2
1. Bit
2. Sleeve

OPERATION

12
Installing or removing bit
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing the bit.
Use only the driver bit or socket bit shown in the figure. Do
001761
not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the arrow
001762
and insert the bit into the sleeve as far as it will go. Then
release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow
and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the sleeve, the
sleeve will not return to its original position and the bit
will not be secured. In this case, try re-inserting the bit
according to the instructions above.
The proper fastening torque may differ depending upon the
kind or size of screws, the type of materials to be fastened,
the condition of the threads, etc. Before starting your job,
always perform a test operation to verify adequate fastening
torque.
Hold the tool firmly and place the point of the driver bit in the
screw head. Apply forward pressure to the tool to the extent
that the bit will not slip off the screw and turn the tool on. As
soon as the screw becomes tight, the clutch will cut in and
the motor will stop automatically. Release the switch trigger.
NOTE:
• Hold the tool pointed straight at the screw, or the screw
and/or bit may be damaged.
• If the motor will not start even after you pull the trigger,
release the trigger. Then pull the trigger again after
turning the bit slightly with your fingers.