Starting Warm Engine - Echo CS-310 Operator's Manual

CS-310
6. Pull choke control knob all the way OUT (CLOSED [
choke position).
• After choke control knob is pulled and then knob is
returned to original position, throttle remains slightly open
(fast idle latch condition).
• The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
• Do not start engine before chain brake is locked.
7. Securely hold the chain saw and pull starter handle several
times until first starting sound.
8. Push choke control knob all the way IN (OPEN
position).
9. Pull starter handle to start the engine.
Note: Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the
casing.
• After starting the engine, immediately squeeze and then release throttle trigger to release fast idle
throttle latch, otherwise severe brake damage may occur.
• Never use fast idle throttle latch for cutting.
• Use the fast idle throttle latch only in starting.
Note: If engine does not start after 5 pulls, repeat instructions.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.

Starting Warm Engine

Make sure the bar and chain are free from any obstruction
when starting the chain saw.
1. Move chain brake lever fully FORWARD to LOCK chain brake
before starting.
2. Confirm there is fuel and chain oil in the tanks.
3. Move ignition switch UP to "RUN" position.
X7503274200
© 11/2014 ECHO Inc.
]
choke
OPERATION
B
Chain brake
21