Preparation For Use - Echo CS-310 Operator's Manual

CS-310

Preparation For Use

Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury
may result.
Note: The machine may be delivered with guide bar, tip guard, and
saw chain separated. Install guide bar, tip guard, and saw
chain as follows.
Tip Guard to Bar Instructions
Tools Needed: Two 11 mm (7/16 in.) Wrenches. For saws with tip
guard P/N 2894901 and Symmetrical or Asymmetrical
Low-Kick type (Double Guard) guide bars.
1. Install bolt (A) in rear hole (B) of tip guard and through front
hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in tip guard must engage recess (E)
in guide bar.
3. Securely tighten nut (F) and bolt (A).
Guide Bar and Saw Chain Installation/Removal
1. Release the cylinder cover latches, and remove the cylinder
cover.
2. Remove spark plug lead.
3. Remove sprocket guard nuts (A) and remove sprocket guard
(B).
4. Remove guide bar and saw chain if necessary.
Note: See "Maintenance and Care" section for guide bar/saw chain
maintenance procedures.
X7503274200
© 11/2014 ECHO Inc.
DESCRIPTION
For more information
scan this QR code.
A
D
B
E
C
F
For more information
scan this QR code.
B
A
15