Lp/Propane Gas Conversion - Frigidaire FGGC3665KBC Installation Instructions Manual

30" and 36" models
Table of Contents

Advertisement

Available languages

Available languages

1. Wall
Outlet
Location
12"
_,1
,_._(30.58 cm)
12_0.3 cm)_'l_J
10"
<25._cm>
120Vgroundedoutlet
on rearwall.
_[_Center line
22"
Of unit
(55.9 cm)
, NOTE: I f an outlet
l
t is not available,
, haveone installedby
'l a qualifiedtechnician.
" " ._:Center
line
Of unit
Figure 5
2. Cooktop
Installation
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
After inserting
the cooktop
into the countertop
opening,
make sure the unit is sitting
on the metal
flange
around the top of the burner box. Cooktop
must not sit on the glass or the porcelain
top. Avoid
cutting
an oversized
hole in the countertop.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Clamp
Down
Information
Once the cooktop is installed in the counter opening,
you must clamp the unit down as shown.
Seal (Porcelain
Cooktop
(Glass
Cooktop
Only)
or Porcelain)
_
/
,
_
_
_
Countertop
Angle
Bracket__
_
_
_
fl _Thumb
Screw
Figure 6
To clamp down, insert an angle bracket into the slot
on each side of the unit as shown. Run thumb screw
up through the bracket, up against the bottom of the
counter. Tighten until the unit draws down and is secure.
3. Provide
an Adequate
Gas Supply
This cooktop is designed to operate on natural gas at 4"
of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper operation,
the maximum inlet pressure
to the regulator must be no more than 14" of water
column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1 " (or 2.5 kPa) greater than the regulator manifold
pressure setting. The regulator is set for 4" of manifold
pressure, the inlet pressure must be at least 5".
The gas supply line to the range should be 1/2" or 3/4"
pipe.
4. LP/Propane
Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
A kit for converting to LP gas is supplied with your
cooktop. The kit is marked "FOR LP/PROPANEGAS
CONVERSION".
The conversion must be performed by a qualified service
technician in accordance with the kit instructions and
all local codes and requirements. Failure to follow
instructions could result in serious injury or property
damage. The qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate conversion
can result in serious personal injury and property
damage.
Important:
Remove all packing material and literature
from cooktop before connecting gas and electrical
supply to cooktop.

Advertisement

Table of Contents
loading

Table of Contents