Frigidaire CGDS3065PFB Installation Instructions Manual page 12

if Accessories Needed:
installation With Backguard
The cutout depth of (21 3/4" (55,2 cm) Min., 22 1/8"
(56,2 cm) Max.) needs to be increased to 24" (61
cm) when installing a backguard.
installation With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation With Side Panels
A Side Panels kit can be ordered through a Service
Center. Note: Install cabinet doors 31" (78.7 cm)
rain. apart so as not to interfere with range door
opening.
Leveling the Range
| lVlodels Equipped with Levelinq Device
Level the range after installation in the cutout opening.
1. Open the range drawer. The leveling screws
control the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass) surface
is sitting level on the countertop.
a.To adjust the front legs, use a wrench on the
leg base and turn counterclockwise to lower or
clockwise to raise the range.
b.To adjust the rear legs, use a ratchet or
a nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise
the range.
3. Check if the range is level by installing an oven
rack in the center of the oven and placing a level
on the rack (Figure 14).
4. Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5. if the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
Front
Leveling
Leg
LOWER
RAISE Figure 13
Models Equipped with Levelin_
Level the range and set cooktop height before
installation in the cut-out opening.
1. install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 14). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 26).
3. Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness.
Figure 14
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be
hot enough to cause burns.
Remove all packaging from the oven before testing.
Check Burner Cap Placement
it is very important to be sure that all surface burner
caps and burner grates are properly installed and in
the correct locations before operating the appliance.
Please note that the burner heads are secured to
the cooktop. The cooktop is not removable. Do not
OvToe or lift the cooktop.
prevent flare-ups and avoid
creation of harmful by-products, do not use the cooktop
without all burner caps properly installed to insure
proper ignition and gas flame size.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use. DO
not allow spills, food, cleaning agents or any other
material to enter the gas orifice holder openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
sure that all round style burner caps are correctly in
place on round burner heads.
12