Kenmore 795.7219 Use & Care Manual page 14

Grab-n-go bottom freezer refrigerator
Hide thumbs Also See for 795.7219:
Table of Contents

Advertisement

Reinstalllng
the Refrigerator
Door
Left Door
1. Lower the door onto the middle
hinge pin (10).
2. Fit the top hinge (7) over the hinge lever latch (8) and
into place. Rotate the lever (6) clockwise
to secure the
hinge.
3. Install the grounding
screw (5) and connect the two
wire harnesses (4).
4. Push the water tube (3) located
at the top of the left
door into the hole beside the left hinge on the top of
the cabinet
until it exits through the back.
5. Insert the water supply tube (3) into the connector
until
you see only one scale mark. Fully insert the tube over
5/8 in. (15 mm).
6. Hook the tabs on the left side of the hinge cover (1)
under the edge of the top hinge (7) and position the
cover in place. Insert and tighten the cover screw (1).
(2)
(3)
r
J
(7)
(8)
Right Door
1. Lower the door onto the middle
hinge pin (9).
2. Fit the top hinge (4) over the hinge lever latch (5) and
into place. Rotate the lever (3) counterclockwise
to
secure the hinge.
3. Hook the tabs on the right side of the hinge cover (2)
under the edge of the top hinge (4) and position the
cover in place. Insert and tighten the cover screw (1).
_-(2)
(4)
A
CAUTION
jfJ
(9)
Cotiet
Tube
Scale Mark
Clip --
After
inserting,
pull the tube
to
make
sure that
it is secure
and
reinsert
the clip.
14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents