MoweF
©
(5) 1-3/16
O.D.Washers
(1)Srna,_
Retainer Springs
(5) Large
Retainer Springs
(2) Rear
\\
Lift Link
>_;
Assemblies _
,/?
(t) Front _
Lift Link
_
Assembly
_
If Equipped
(1) Anti-Sway Bar
(t) 3/40,D,
Washers
(1) Small Retainer
Springs
Mower Front Wheel
(1) Shoulder Bolt
(1) 1-1/40.D.
Washer
(1) Wheel
(t) 3/8-16
Locknut
Quick Connect
Slope Sheet
(1) Oil Drain Tube
A
O_
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes.
To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely.
Use the correct tools
as necessary to ensure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
Flashlight
When right or left hand is mentioned in this
manual, itmeans when you are inthe operating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons
from carton.
•
Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
•
Remove mower and packing materials.
•
Check for any additional loose parts or
cartons and remove.