Makita G1200R Instruction Manual page 13

AC application
- Check the voltmeter for proper voltage.
The generator is thoroughly adjusted and tested in
the factory. If the generator does not produce the
specified voltage, consult your nearest Generator
dealer.
-Check the electrical appliance to see if its switch is
turned
off,
then connect the appliance to the
generator.
- Switch on the appliance.
Electrical appliance
Lamp, electrical heater, radio, stereo
sets, etc.
Electric tools
e
Applicable AC wattage
:
The following table shows the maximum wattage of various appliances which can be
connected to the generator. Before connecting an appliance, make sure its wattage is
within the range.
Applicable limit
60Hz
up to
1
ooow
up to about 600W
CAUTION]
1, When connecting plural appliances make sure the total wattage does not exceed
the generator's rated output. Otherwise the generator will not operate due to
excessive wattage.
2. Some power tools require a large starting current. In these cases, it may not be
possible to use the generator. Refer to page 20, or consult your dealer to obtain the
necessary information.
3.
When overloaded, the AC circuit breaker pops out to cut
off
the current. In such
a
case, make sure that the applied wattage of the appliance has not exceeded the
wattage limit and that there are no defects in the appliance. Then push the circuit
breaker back into the "ON" position.
-
10
-