Recording Tv Programmes Using The G-Code System - Sony RDR-HX720 Operating Instructions Manual

Recording TV programmes
using the G-Code system
The G-Code system is a feature that
simplifies setting the timer. Just enter the G-
Code programming number listed in the TV
programme guide. The date, time, and
programme position of that programme are
set automatically.
Check that the programme positions are
correctly set in "Channel Setting" in the
"Basic" setup (page 79).
Number
buttons
z REC
x REC
STOP
1
Press TIMER.
2
Select "G-Code No." using M/m, and
press ENTER.
3
Press the number buttons to enter the
G-Code programming number, and
press ENTER.
The date, start and stop times,
programme position, recording mode,
etc. setting (page 39) appear.
• If you make a mistake before pressing
• If you want to change the setting, press
TIMER
• If you want to re-enter the G-Code
</M/m/,,
ENTER
4
Select "OK," and press ENTER.
The TIMER REC indicator lights up on
the front panel, and the recorder is ready
to start recording.
To stop recording during timer recording
Press x REC STOP.
Note that it may take a few seconds for the
recorder to stop recording.
If the timer settings overlap
See page 40.
To extend the recording duration time
while recording
See page 40.
To confirm, change, or cancel a timer
recording
See "Checking/Changing/Cancelling Timer
Settings (Timer List)" on page 44.
z Hint
The Rec Mode Adjust function also works with this
timer method (page 40).
ENTER, press </, and re-enter the
correct number.
</, to select the item and press M/m
to change the setting.
programming number, select "G-Code
No.," and press ENTER. Then re-enter
the G-Code programming number.
41
,continued