Makita AG090, AG125 Instruction Manual page 6

Nail guide
Gas pipe Live wire
6
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
Make sure the safety system is in working order before oper-
ation. The tool must not operate if only the nail guide is
pressed against the wood.
Test for possible faulty operation with nails unloaded and the
Trigger
adjuster set to the number 1.
Adjuster
Check walls, ceilings, floors, roofing and the like carefully to
avoid possible electrical shock, gas leakage, explosions, etc.
caused by striking live wires, conduits or gas pipes.
Use only nails specified in this manual. The use of any other
nails may cause malfunction of the tool.
Do not permit those uninstructed to use the tool.