Makita AG090, AG125 Instruction Manual page 5

Only those involved in the work should be in the vicinity. Chil-
dren especially must be kept away at all times.
There may be local regulations concerning noise which must
Shutter be complied with by keeping noise levels within prescribed
limits. In certain cases, shutters should be used to contain
noise.
Bang !
Securing the trigger in the ON position is also very danger-
ous. Never attempt to fasten the trigger.
Do not operate a tool if any portion of the toot operating con-
trols is inoperable, disconnected, altered, or not working
properly.
Trigger
Operate the tool within the specified air pressure of 4.5 - 8.5
kgf/cm²G (65 - 120 PSIG) for safety and longer tool life. Do
not exceed the recommended max. operating pressure of 8.5
kgf/cm²G (120 PSIG). The toot should not be connected to a
source whose pressure potentially exceeds 14.0 kgf/cm²G
(200 PSIG).
Never use the tool with other than compressed air. If bottled
gas (carbon dioxide, oxgen, nitrogen, hydrogen, air, etc.) or
combustible gas (hydrogen, propane, acetylene, etc.) is used
as a power source for this toot, the tool will explode and
cause serious injury.
5