Load
nails into
the magazine
so that the nail
points
will be set into the groove at the bottom of the maga-
zine.
Move
the
nails
into the ejection
slot as
far
as
they
will go.
CAUTION
:
Always load the same type and size of nail into the
magazine.
If
you load the tool with different types
and/or sizes a t the same
time,
a malfunction may
result.
To close the slide door, slide
it toward the driver guide until the slide door is locked by the leaf
spring.
Adjusting depth of nailing
CAUTION :
Always lock the trigger and disconnect the hose before adjusting the depth of nailing.
\
3river guide
/
Groove
The depth
of
nailing can be adjusted by moving the
driver guide up or down. When moving the driver guide
to the higher position, you can obtain a deeper depth
of nailing; when moving it t o a lower position, you can
obtain the shallower depth of nailing. To adjust the
depth of nailing, proceed as follows:
1 . Remove hex wrench 3 from the hook.
.
2.
Turn the adjusting bolt with hex wrench 3 until the
adjusting bolt contacts the projection of the center
plate.
I
Hex wrench 3
I
Projection
of
center plate
I
1 1