Caster/Caster Foot Assembly; Filter Removal And Installation - RIDGID WD06700 Owner's Manual

SP6737-1 Ridgid 7/26/10

Caster/Caster Foot Assembly

1. Turn the dust drum upside down on the
floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.

Filter Removal and Installation

Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small center hole in the top of
the filter over the Qwik Lock™ stud on
the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
3:33 PM Page 5
Caster
Foot
Dust
Drum
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Lid
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
5
Caster
Caster Stem
Caster Ball
Pin
Hole
PUSH
DOWN
PULL
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik
Lock™
Stud
Filter
Cage
UP