Caster/Caster Foot Assembly; Wet/Dry Vac Assembly - RIDGID VAC12000 Owner's Manual

SP6949 VAC12000 ESF-1.qxp_SP6949 5/15/15 12:23 PM Page 5

Caster/Caster Foot Assembly

With the lid assembly removed from the
drum, and the drum upside down on the
floor:
1. Insert the 4 caster feet into the bottom
of drum, as shown.
2. Push each of the caster feet until the
feet are flush with bottom of the dust
drum.
3. Insert each of the caster stems into
the sockets of the caster feet, as
shown (4 places).
4. Push on the casters until the ball of
each caster stem is inserted all the
way into the socket. You will hear the
ball snap into the socket and the
casters will swivel easily when
positioning is correct.
5. Turn the drum upright.

Wet/Dry Vac Assembly

1. Locate the lid assembly and the drum/
caster foot assembly (assembled
previously).
2. Position the lid assembly with the inlet
of the unit located in line with the drain
cap on the dust drum.
3. To assemble the lid assembly to the
drum/caster foot assembly, lower the
lid assembly onto the dust drum.
Rotate both latches down until you
hear them snap over the lip of the
drum.
Drum Latch
Caster
Foot
Lid
Assembly
Dust
Drum
Drum Latch
Drum Lip
5
Caster
Caster Stem
Caster Ball
Pin
Hole
Dust
Drum
Inlet
Drain
Cap