Figure 3- Rear Panel Layout
9. Stereo Input Left
11. Stereo Input Right
13. CH1 Output
15. Power Switch
S
I
L
T E R E O
N P U T
E F T
This ¼" input receives the left analog output of the DAW or of any stereo source.
S
O
T E R E O
U T P U T
This ¼" output is hardwired to Stereo Input Left, allowing an unbroken connection from the left analog
output of the DAW to the destination (i.e. monitor controller, mixer, etc.).
S
I
R
T E R E O
N P U T
I G H T
This ¼" input receives the right analog output of the DAW or of any stereo source.
S
O
T E R E O
U T P U T
This ¼" output is hardwired to Stereo Input Right, allowing an unbroken connection from the right analog
output of the DAW to the destination (i.e. monitor controller, mixer, etc.).
CH1 O
U T P U T
This ¼" output is hardwired to the CH1/Mono Input on the front panel, allowing an unbroken connection
from the CH1 /Mono Source to the analog input of the DAW.
CH2 O
U T P U T
This ¼" output is hardwired to the CH2 Input on the front panel, allowing an unbroken connection from the
CH2 source to the analog input of the DAW.
P
S
O W E R
W I T C H
The power switch is a two position rocker switch.
AC P
C
O W E R
O N N E C T O R
This unit accepts AC Power in the range of 93-264 Volts at 47-63 Hertz. Adjustment to AC power input
in this range is automatic; there are no settings to change.
L
E F T
R
I G H T
10. Stereo Output Left
12. Stereo Output Right
14. CH2 Output
16. AC Power Connector
8
The Rear Panel