Table of Contents
Advertisement
1. First, complete all steps listed in the section titled Setup for Playback Listening included
previously in this chapter of the manual.
2. Select CH1 and lower the Volume to zero.
3. Select CH2 and lower the Volume to zero.
4. Connect one live signal source to CH1/Mono Input.
5. Connect the 2nd live signal source to CH2 Input.
6. Select CH1 and raise the Volume to the optimal level.
7. Select CH2 and raise the Volume to the optimal level.
CH1+2, CH1, and CH2 are three completely independent Volume settings. Changing the Volume of CH1
or CH2 does not affect the Volume of CH1+2, or vice versa. By selecting either CH1 or CH2 and rotating
the knob, the unit will suddenly switch to stereo mode Volume settings. If CH1 or CH2 are set to a much
higher Volume setting than CH1+2, a sudden increase in loudness will be heard, and damage to
hearing/headphones may result. To prevent damage in case of accidentally switching to stereo mode, it
is highly recommended to make sure that CH1 and CH2 are both muted during setup.
1. First, complete all steps listed in the section titled Setup for Playback Listening included
previously in this chapter of the manual.
2. Select CH1+2 and lower the Volume to zero.
3. Connect a live stereo signal source to the CH1/Mono Input and to the CH2 Input. Use balanced
cables for balanced signals or unbalanced cables for unbalanced signals.
4. Connect CH1 Output and CH2 Output to the analog record inputs of your DAW. Use balanced
cables for balanced signals or unbalanced cables for unbalanced signals.
5. Select CH1+2 and raise the Volume to the optimal level.
CH1+2, CH1, and CH2 are three completely independent Volume settings. Changing the Volume of CH1
or CH2 does not affect the Volume of CH1+2, or vice versa. By selecting CH1+CH2 and rotating the knob,
the unit will suddenly switch to mono mode Volume settings. If CH1+2is set to a Volume much higher
than CH1 or CH2, a sudden increase in loudness will be heard, and damage to hearing/headphones may
result. To prevent damage to in case of accidentally switching to mono mode, it is highly recommended
to make sure that CH1+2 is muted during setup.
11
Setup and Use
Advertisement
Table of Contents
