Table of Contents
Advertisement
plug still does not fit, contact a qualified electrician to
install the proper wall outlet. Do not modify the appliance
plug, power cord receptacle, or power cord plug in any
way.
m
WARNING
Electric shock may cause SEVERE INJURY or
DEATH. Heed these warnings:
• Do not allow any part of the electric pressure washer
to make contact with water while it is in operation. If
the appliance becomes wet while turned off, wipe dry
before starting.
• Do not use an extension cord over 25 ft. The
pressure washer comes equipped with a 35 ft power
cable. Combined cord length must not exceed 60 ft.
Any extension cord must be 14-gauge (or heavier) to
safely power the pressure washer.
• Do not touch the appliance or its plug with wet hands
or while standing in water. Wearing rubber boots
offers some protection.
EXTENSION CORD CHART
Cord Length:
Min. Wire Gauge (A.W.G.):
6. To prevent the appliance cord from disconnecting from the
extension cord during operation, make a knot with the two
cords as shown in Table 1.
Table 1. Method of Securing Extension Cord
Cord set
(A) Tie cord as shown
(B) Connect plug and receptacle
7. Do not abuse the cord. Never pull the pressure washer
by the cord or yank the cord to disconnect it from the
receptacle. Keep the cord away from heat, oil, and
sharp edges.
Risk of electrocution
• Inspect cord before using.
• Do not use if cord is damaged.
• Keep all connections dry and off the ground.
m
• Do not touch plug with wet hands.
• Keep cord away from heat and sharp edges.
• Do not spray electrical apparatus and wiring.
Risk of explosion
• Do not spray flammable liquids.
• Do not use acids, bases, solvents, or any flammable
Additional safety instructions
• High-pressure: keep clear of nozzle.
• Injection hazard: equipment can cause serious injury if the
• Do not point the gun at anyone or at any part of the body.
• In case of skin penetration, seek medical aid immediately.
25 ft (7.6 m)
• Before servicing, cleaning, or removing any parts, shut off
14
• This machine is not suitable for connection to the potable
Product Description
Purpose
• This high-pressure electric power washer is intended for
Appliance cord
Areas of application
• Never use the machine in potentially explosive areas under
• The operating temperature must be between 32ºF (0ºC) and
• The machine consists of an assembly with a pump, which
• Do not cover or modify the spray wand or the spray nozzles
• The high-pressure electric power washer is designed to be
• Do not use water that is dirty, gritty, or contains any
3
material in this product. These substances can cause
physical injuries to the operator and irreversible damage to
the machine.
spray penetrates the skin.
the power and relieve pressure.
water mains.
residential use to clean vehicles, machines, buildings,
facades, etc.
any circumstances!
104ºF (40ºC).
is encased in a shock-absorbing housing. To provide the
operator with an optimal working position, the machine is
equipped with a spray wand and a non-slip handle grip,
whose shape and configuration comply with applicable
regulations.
in any way.
used with cold or lukewarm water; higher temperatures can
damage the pump.
chemical products, as these could impair operation and
shorten the life of the machine.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SPX3000 and is the answer not in the manual?
Questions and answers
Where is the fuse on a SunJoe SPX3000?
When under pressure water gushes from under the plastic causal where the red arrow is pointing. I've replaced the washer and it continues to leak.
Your Sun Joe SPX3000 may be leaking water from under the plastic casing due to internal hose or reservoir tank issues. Users have reported that internal hoses or the reservoir tank leak badly, preventing water from gathering properly. This issue occurs even without electricity being used. If replacing the washer did not fix the problem, the leak might be coming from an internal component that needs inspection or replacement.
This answer is automatically generated
Machine won't start
The Sun Joe SPX3000 machine may not start due to the following reasons:
- Power failure or not plugged in: Ensure the machine is connected to a working outlet.
- Defective socket: Check the power cord, reset the GFCI, and try a different outlet.
- Blown fuse: Replace the fuse and turn off other machines using the same circuit.
- Defective extension cord: Try running the unit without an extension cord.
This answer is automatically generated
The circular scrubber will not turn
The circular scrubber on the Sun Joe SPX3000 may not turn if there is low water pressure, air in the pump, or a blockage in the hose or nozzle. It could also be due to a malfunction in the attachment or insufficient flow caused by a faulty connection. Ensure all hoses are airtight, the nozzle is clean, and the water supply is adequate.
This answer is automatically generated
When you are looking at the back of the pressure washer with the back removed you can see that water is leaking on the left side of the aluminum housing. The pressure washer was drained and stored in a heated basement all winter. How can I replace this part and how much will it cost?