m
WARNING!
Use only detergents specifically designed
for use with pressure washers. DO NOT USE household
detergents, acids, alkaline solutions, bleaches, solvents,
flammable material, or industrial grade solutions. These could
damage the pressure washer. Many detergents may require
mixing prior to use. Prepare the cleaning solution as instructed
on the solution bottle.
1. Remove the cap(s) and detergent suction tube(s) from the
detergent bottle(s).
2. Gently pull each of the onboard detergent tanks out of its
storage position and fill each tank with detergent (Fig. 24).
Fig. 24
Detergent tank
3. Insert the suction tube(s) back into the tank(s) and cap the
tank(s) closed. Push the tank(s) back into storage position
on the unit.
4. Use the detergent dial to select which of the two detergent
tanks the unit will draw from and to control the rate of
flow. When not working with detergent, such as when
using a non-soap nozzle, turn the detergent dial to the
center (O) (Fig. 25).
5. Install the Soap nozzle (black) on the spray wand (Fig. 23).
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
6. Turn on the pressure washer. Pull the trigger to operate
the unit. The liquid detergent will automatically mix with
water and be discharged through the nozzle.
7. Turn the detergent dial to adjust the suction volume of the
detergent solution (Fig. 25).
8. Apply detergent from the bottom to the top of the dry
9. Allow the detergent to remain on the surface for a short
m
Pressure washer
detergent
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
10. When you have finished using the detergent injection
m
will cause the injection system to become clogged and
inoperable.
Rinsing with the pressure washer
1. Turn off the pressure washer and shut off the water supply.
2. Pull the trigger to release water pressure.
3. Engage the safety lock on the trigger handle by pushing
4. Remove the nozzle by placing your hand over the nozzle
11
Fig. 25
Detergent selection dial
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
time before rinsing. Do not allow the detergent to dry on
the surface.
CAUTION!
Damage may occur to painted surfaces if
system, remove the detergent suction tube from the
detergent bottle and insert it into 1.3 gal (5 L) of fresh
water. Siphon water at low pressure for one minute so that
all the detergent is flushed through the system. Remove
the detergent bottle and rinse it until it is thoroughly
cleaned.
CAUTION!
Failure to follow these cleaning instructions
up on the safety lock until it clicks into the slot (Fig. 22).
while pulling back on the Quick-Connect collar.