The Stone Bake Oven Primo Assembly And Operation Manual page 20

Step 4
- Connect the two "Top Short" components to the
"Corner Connecters" (as shown on the right) with the
CSK Bolt, fastening with the M8 Nut. Do not fully tighten,
just secure by hand for the moment.
- With the still unfastened ends of the "Top Short"
components, align with the "Corner Connectors" that house
the other "Top Long" component that was earlier fastened
to complete a square frame. Again do not fully tighten, just
secure by hand.
- Once you have connected all your "Top" components, you are able to
stand your Primo Stand upright to complete the remaining part of the
erection (as shown on the right).
- Take the "Bottom Long" components and attach through the aligned
holes at the bottom end of the "Leg" with the RHD Bolts and the
M8 Nuts, make sure these components correspond to the "Top Long"
Components otherwise the stand will not be square. Do not fully tighten.
- Repeat this process with the "Bottom Short" components, double checking
that the "Long" and "Short" components on the top and bottom correspond.
- Once fully erected, you are able to start to fully tighten with the
Spanner and Hex Key provided (as shown on the right).
Only place your Primo Oven within
your Primo Stand when it has been
fully erected and fully secured using
the tools provided.
The Primo Stand is fully
weatherproof, made from stainless
steel. There is no need to treat your
stand from the elements.
© The Stone Bake Oven Company 2010. All rights reserved.