The Stone Bake Oven Primo Assembly And Operation Manual page 19

Step 1
- Remove all contents from box and neatly lay out on floor.
- Carefully peel the protective wrap off each component of your Primo Stand.
- Make sure the you are erecting the stand on a flat surface.
Step 2
Set aside:
4x Legs, 4x Corner Connectors, 8x RHD Bolts and 8x M8 Nuts
- Align the four holes in the top of the "Legs" with the four holes in
the "Corner Connector".
- Once Holes are aligned, place the first RHD Bolt through the
first hole, then twist the M8 Nut onto the RHD Bolt but do not
tighten, as shown on the right.
- Repeat this process with three remaining RHD Bolts and M8 Nuts.
- Once all four RHD Bolts have been successfully positioned with
M8 Nuts loosely fixed, you are then able to tighten fully with the
Spanner and the Hex Key supplied (as shown on the right).
- Make sure you use the tools provided to tighten each bolt
adequately, failure to tighten adequately may jeopardise the
stands stability.
- Once you have completed the first "Leg" and "Corner Connector"
fastening, repeat the exact process with the remaining three
"Legs" and "Corner Connectors".
Step 3
- Align the "Top Long" component holes with matching holes in the
"Corner Connector" that is attached to the "Leg".
- Use the CSK Bolt through the aligned holes and apply the M8 Nut,
twist until secured but do not fully tighten.
- Repeat the process, as shown below.
- Repeat the same process with the other "Top Long" component and the
"Corner Connectors" attached to the "Legs"
© The Stone Bake Oven Company 2010. All rights reserved.