Launching The Ebee - Canon S110 RGB User Manual

Pre-flight checklist:
1. Check remaining space on SD card and install it into
camera.
2. Set/check camera date/time.
3. Select
tings).
4. Remove the S110 camera's battery².
5. Place the camera's dial lock on.
6. Check/clean lens.
7. Plug the S110 camera into the eBee.
8. Connect the eBee's battery.
9. Connect to the eBee with eMotion.
10. Verify that the right camera model is selected in eMo-
tion.

3 Launching the eBee

The take-off procedure is the same as described in your eBee User Man-
ual. Nevertheless, the S110 camera is slightly heavier (+20 grams / 0.7 oz)
than the drone's default payload. Therefore, be sure to launch the eBee
with a good initial speed against the direction of the wind.
² Not applicable if your eBee serial number starts with EB-01-.
on the mode dial (or any desired custom set-
C
21