Faq Und Tipps - ABB -free home System Manual

08 FAQ und Tipps

08 FAQ und Tipps
Mounting the System Access Point (Fig. 47)
The System Access Point is installed surface-mounted.
The bus line is always inserted on the rear side. The 230
V power cord and the optional CAT wire can also be in-
serted on the rear side or installed surface-mounted. In
case of surface-mounting, the wires are inserted from the
underside of the device via the available breakout open-
ings.
If the CAT wire is inserted on the rear side, it should be
ensured that the distance between centres of the two
installation boxes amounts to 80 mm.
.
72 │
Connection of the CAT wire
CAT wires that are already patched can be connected
directly via the RJ45 female connector of the System
Access Point.
If an installation line is being used, the adapter cable
enclosed with the device is to be used. On one end of this
cable the installation cable can be installed via LSA tech-
nology. On the other end is an RJ45 plug, which can be
connected with the female connector of the System Ac-
cess Point.
Commissioning is always carried out via the System Ac-
cess Point. A smartphone, tablet or PC is required for
commissioning. No additional software is required. The
use of the free-of-charge free@home® app is recom-
mended for commissioning via smartphone or tablet.
ABB-free@home
System Manual
®