Figure 47. Installing the system battery
1.
system battery
Next steps
1.
Install the cooling shroud.
2.
Follow the procedure listed in
3.
While booting, press <F2> to enter the System Setup and ensure the battery is operating properly.
4.
Enter the correct time and date in the System Setup Time and Date fields.
5.
Exit the System Setup.
Hard-drive backplane
Depending on your configuration,
8–Hard-drive
2.5 inch (x4) SAS/SATA backplane
system supports
10–Hard-drive
2.5 inch (x10) SAS/SATA backplane that supports X10 and 4 (PCIe SSDs)
system supports
24–Hard-drive
1.8 inch (x24) SAS/SATA backplane
system supports
Removing the hard-drive backplane
Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
Remove all hard drives.
After working inside your
Safety
instructions.
Before working inside your
2.
positive side of the battery connector
system.
system.
107