Tot Pre-Alert; Tot Reset; Troubleshooting - RCA BR200V Instruction Manual

18
TOT Re-key
1. TOT Re-key sets the amount of time transmissions
are prohibited after the time-out timer has been
activated.
2. If transmitting is prohibited, pressing the PTT
button will cause a warning tone.

TOT Pre-alert

1. The radio emits a pre-alert tone indicating that
radio will soon stop transmitting due to the TOT.
2. After the alarm tone, if the transmission
continues past than the preset time limit, the
TOT will be activated, which prevents the radio
from transmitting.

TOT Reset

1. TOT Reset is the delay time between releasing
the PTT button and resetting the Time-Out
Timer.
2. If the time of releasing the PTT button is
shorter than the TOT Reset, the transmitting
prohibition countdown will continue.
BR200 TM Professional Two-Way Radio Instruction Manual
Copyright © 2015 RCA Communications Systems

TROUBLESHOOTING

Problem
• Battery pack may not be installed
The radio cannot
properly. Remove the battery pack
be switched on or
and install it again.
• Battery power may be insufficient.
no display after
Recharge or replace the battery
switched on.
pack.
The battery power
• Battery is worn out. Replace with a
runs out quickly
new battery.
after charging.
• Determine if other callers are using
the same channel.
• CTCSS/DCS signaling may not be
identical. Please talk to your RCA
Cannot talk to
Communications Systems dealer
or hear other
about reprogramming.
members in your
• Make sure the setting of the
group.
selective signaling 5-Tone in the RX
Squelch Mode is correct.
• Members are outside of
communication range.
• Talk to your RCA Communications
Other calls from
Systems dealer about changing
non-group
the CTCSS/DCS tone. Be sure the
members are heard
CTCSS/DCS tone is the same on all
on the channel.
radios in your group.
Solution