Download  Print this page

Makita 43901D Instruction Manual page 7

Makita cordless saw - bandsaw user manual
Hide thumbs

Advertisement

If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing saw blade
CAUTION:
Always be sure that the tool
is
switched
off
and the battery cartridge
is
removed before
installing or removing the blade.
Loosen the blade securing bolt fully with the
hex
wrench. Keep the back edge of the blade
against the roller and insert the blade be-
tween the blade clamp and the slider
as
far
as
it will go. Make sure that you are inserting
the blade into the proper position.
Fit the pin on the slider in the hole in the
blade shank.
Note
:
The hole in the blade shank will be aligned
with the pin on the slider when the blade
shank hits against the spring pin on the
slider.
Tighten the bolt securely while making
sure that the blade will not be extracted
even though you try to pull
it
out.
CAUTION
:
If you tighten the bolt without the pin
on the slider fitting properly in the hole
in the blade shank, the pin or the blade
shank will be damaged. This may cause the
blade to be extracted unexpected I y during
operation.
Roller
Blade clamp
Blade
Blade clamp
Blade shank
Slider
Hex. wrench
y
<Shae
I
21
To remove the blade, follow the installation procedures in reverse.
7

Advertisement

Table of Contents
loading

  Related Manuals for Makita 43901D

This manual is also suitable for:

4390dw4390d