Installing or removing battery cartridge
Always switch off the tool before insertion or removal of
* T o remove the battery cartridge, pull out
plate on the tool and grasp both
sides of the cartridge while withdrawing
it from the barrel.
.To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
place. Snap the set plate back into place.
Be sure to close the
plate fully before
using the tool.
Do not use force when inserting the battery cartridge.
I f the cartridge does not slide in easily,
is not being inserted correctly.
charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective makrings on the fast charger.
Insert the cartridge fully into the port
rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
charging light does not come on,
press the reset button (yellow) first, then
the start button (red). If the charging light
goes out within 10 seconds even after pressing the reset button and start button a couple
of times, the battery cartridge is dead. (CAUTION: Wait for more than 5 seconds after
the charging light
out to press the reset button again.) Replace
When the charging light goes out after about one hour, you may remove the fully charged
After charging, unplug the charger from the power source.
Your new battery cartridge
not charged. You will need to charge
Do not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
I f you try to charge
just-operated tool, sometimes
will not come on. If this occurs,
the cartridge cool off for
while. Then re-insert it
charge it once more.