Table of Contents
Advertisement
http://jdwxzlw.5d6d.com/?fromuser=华盛维修
3. OPERATING INSTRUCTIONS
This procedure gives you instructions for installing and using the 9Glr color display.
1.
Position the display on the desired operation and plug the power cord into a convenient AC outlet.
Three-wire power cord must be shielded and is provided as a safety precaution as it connects the
chassis and cabinet to the electrical conduit ground. If the AC outlet in your location does not have
provisions for the grounded type plug, the installer should attach the proper adapter to ensure a safe
ground potential.
2.
Connect the 15-pin color display shielded signal cable to your signal system device and lock both
screws on the connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Apply power to the display by turning the power switch to the "ON" position and allow about thirty
seconds for display tube warm-up. The Power-On indicator lights when the display is on.
4.
With proper signals feed to the display, a pattern or data should appear on the screen, adjust the
brightness and contrast to the most pleasing display.
5.
This monitor has power saving function following the VESA DPMS. Be sure to connect the signal cable
to the PC.
6.
If your 9Glr Series color display requires service, it must be returned with the power cord.
家电维修资料网，免费下载各种维修资料
1
6
11
15 - Pin Color Display Signal Cable
DESCRIPTION
RED
GREEN
BLUE
GND
GND
GND-R
GND-G
GND-B
5
10
15
PIN NO.
9.
NC
10.
GND
11.
SYNC. GND
12.
SDA
13.
HORIZ. SYNC
14.
VERT. SYNC (＊VCLK)
15.
SCL
6
DESCRIPTION
Advertisement
Table of Contents
Troubleshooting
